Do you know all the relevant knowledge about mold release agents? Follow the editor of Discount Water based release agent to have a simple understanding!
1. How to use
1. Dilution method: adjust to the required concentration with water, and stir it evenly.
2. After diluting with clean water, spray it on the surface of the mold; the specific dilution ratio should be selected according to the difficulty of mold release of the silicone product. The amount of release agent sprayed during the use process will not cause the surface of the product after molding. Whitening, cracks, watermarks, oil spitting and other bad appearance phenomena.

2. Matters needing attention
1. Avoid high temperature, direct sunlight, keep away from fire, strong acid substances, metal oxides, amine substances and flammable materials. It is suitable for storage in a ventilated place at room temperature (recommended below 25°C).
2. Strictly control the proportion of addition. If the proportion of this product is too much, it is easy to produce blooming phenomenon, which will seriously affect the appearance. If the product produces this phenomenon, it can be eliminated by boiling, secondary vulcanization and other methods.
In summary, the editor of Discount Water based release agent tells: a brief introduction to relevant knowledge about release agents.